Email: eric@proprepshotblasting.com

Ph: 615-351-1433

For the last 33 years, Pro Prep has specialized in concrete floor preparation, this cleans and preps which creates a bonding surface for any coating, sealer, overlayment or stain. Also coating, tile, thin set and carpet removal.

What We Offer

Shot blasting is a method to prep a concrete or metal floor, we can create a very light profile for thin mil coatings or create a heavy profile for thicker coatings or overlayments or anything in between you need. And remove thinner mil coatings, this is a dustless operation.

Before & After

Diamond grinding is another method to prep a concrete floor or remove thin or thick mil coatings, glue, thin set and stains. It depends on what your finish product is on what method we need to do.

Before & After

.

We also have a mobile sandblasting unit that can be run wet (no dust) or dry (some dust). Instead of just doing floors or flat surfaces the sandblaster opens up prepping vertical surfaces such as any coating removal, concrete trenches, concrete walls, brick walls, concrete steps, metal steps, machinery, and just about any kind of hard to get to place you may have. The sandblaster also works very well on any kind of stamped or designer concrete re-dos and pool decks, it preserves all the fine details in the concrete.

Before & After

We work within, a radius of approximately 700 miles of Nashville, Tennessee. No job is too large or too small. We do only prep work, no coatings. However we do work for a lot of coating contractors and usually can recommend a coating installer in your area.